Apc personal powercell manual

PowerChute Personal Edition v3. Load more. Protection Operating System Shutdown. Prevents possible data corruption by performing graceful, unattended operating system shutdown in the event of an extended power outage or computer power problem. Preserves entire state of system and speeds time to recovery. Manageability Automatic self-test.

Periodic battery self-test ensures early detection of a battery that needs to be replaced. Status at a glance. Power performance. Summarizes power problems such as blackouts and electrical noise over time. Convenience Installation. Fast, easy installation takes the guesswork out of configuration for first-time users. Exclusive silent operation at night. Trade in any brand UPS battery back-up for current models. Support Resources and Tools. Resources and Tools. Need Help Choosing a Product or Service?

Software and Firmware Downloads Download the latest software and firmware updates available to keep your APC products performing at their best.

Avoid installing the unit near heat emitting appliances such as a room heater or stove. La salida puede tener corriente aun cuando la unidad no se encuentre conectada al suministro de red. Once your PowerCell has been removed from its shipping container, it should be inspected for damage that may have occurred while in transit. Immediately notify the carrier and place of purchase if any damage is found. The packing materials are made from recyclable materials and should be saved for reuse or disposed of properly.

Your PowerCell may be installed in any protected environment. The location should provide adequate air flow around the unit, in an atmosphere free from excessive dust, corrosive fumes and conductive contaminants. Do not operate your PowerCell in an environment where the ambient temperature or humidity is outside the limits given in the Specifications section of this manual.

The PowerCell is designed to power all modern computer loads and associated peripheral devices such as monitors, modems, cartridge tape drives, external floppy drives, etc. The PowerCell is not rated to power life support equipment as described on the rear cover of this manual. Caution : The output waveform of this UPS is a sine wave approximation suitable for use with modern computer power supplies. Other loads may malfunction or the UPS could be damaged.

In particular, ferroresonant type regulating transformers are not recommended. This UPS contains high performance surge suppression - additional suppression components are not required and are not recommended. If in doubt, please consult the equipment manufacturer or the factory. The UPS must be plugged into a 2 pole, 3 wire grounding receptacle. If an extension cord must be used between the UPS and the nearest wall outlet, use a 3 wire grounding type rated for at least 10 Amps.

Once loads are connected, the indicator illuminates when the UPS is turned on and connected to an outlet whose wiring is improper or inadequate. Note: If your PowerCell indicates a site wiring fault, a qualified electrician should be summoned to correct the service wiring. Your PowerCell is shipped from the factory with its internal battery in a fully charged state. However, the battery may lose some charge during shipping and storage. The battery should be recharged before conducting the following Test for proper operation section 3.

You can be sure that the battery is fully recharged if the PowerCell is left plugged in for at least 6 hours. Your PowerCell may be used immediately upon receipt, but may not provide expected run time in the event of a utility power failure. Welcome to ManualMachine.