Install cameraxpro to k1

The blue splice connector and black inline fuse can be seen in the top right of the photos. The negative black wire was connected directly to the negative terminal of the battery located under the seat.

The USB power module was also placed under the seat by the battery and the USB connector was routed into the storage compartment as seen in the photos. The speaker announces when recording has started, when GPS signal has locked and when recording has stopped. I opted to have the other end of the DVR easily accessible to be able to remove the microSD card as needed to review videos remotely. The K1 recording unit allows for viewing of recorded videos. The videos produced by Innovv K1 motorcycle camera are excellent with a very wide angle of view — degrees.

I chose to aim the camera slightly down in order to not capture as much sky as aiming the camera straight forward. Active 1 month ago. Viewed 60 times. I am new here and I am a noob in cross-compile.

This means that you cannot build the Qt documentation. On Linux systems, you may be able to install libclang by installing the libclang-dev or libclang-devel package, depending on your distribution. On macOS, you can use Homebrew's llvm package. Most likely, the bit host compiler does not work.

Please make sure you have bit devel environment installed. Qt is now configured for building. Just run 'make'. Once everything is built, you must run 'make install'. Prior to reconfiguration, make sure you remove any leftovers from the previous build Although I got warning, I followed with make because I search different solutions to eliminate warnings and nothing work. Can anybody help me, please? Thanks so much! Improve this question. Thanks for the info!

BB code is On. Smilies are On. Trackbacks are On. Pingbacks are On. Refbacks are On. Forum Rules. All times are GMT The time now is PM. Add Thread to del. K1 kit install in User Name. Remember Me? ShopForum Gallery. Mark Forums Read.